日本YUKEN先導式平衡閥，DSG-01-2B2-A240-70

This value is measured for each valve
based on a supply pressure of 14
MPa.There are restrictions on the m
ounting position. Consult Yuken for details.
電氣連接11+ PE連接器[EN175201部分804]
1）返回在DR端口壓力應(yīng)為0.2兆帕或更小，并不會成為負壓。
2）此值被測量為基礎(chǔ)的14兆帕的壓力供給各閥。
3）上有安裝位置的限制。油研咨詢有關(guān)詳情。
（Pres. PS =14 MPa時，粘度：32平方毫米/秒）
滯后0.1％或更少 芯行程來停止毫米±1
極性查看的I / O信號特性的描述。
直線電機電流zui大。 1.5 A
規(guī)格線圈電阻在20°C7Ω
Back pressure at the DR port should be
0.2 MPa or less and not be a negative pressure.
Linear Motor Current Max. 1.5 A
Specification Coil Resistance at 20 °C 7 Ω
Approx. Mass 9.3 kg
Electric Connection 11 + PE
Connector [EN175201 Part 804]
Rated Flow at ⊿P = 7 MPa L/min 130
Max. Operating Pres. MPa 31.5
Proof Pres. at Return Port MPa 21
DR Port Permissible Back Pres. 1) MPa 0.2 or less
Internal Leakage L/min
n about I/O signal characteristics.
(Pres. Ps = 14 MPa, Viscosity: 32 mm2/s)

日本YUKEN先導式平衡閥，DSG-01-2B2-A240-70